Stick Coil (Straight) - BMW R1250 ; 12 13 8 567 157, 12 13 2 624 300 / Beru

Home > Hexhead > Electrical System > Ignition > Coils >

Stick Coil - BMW R1250 ; 12 13 8 567 157, 12 13 2 624 300 / Beru

12 13 8 567 157,12138567157,12 13 2 624 300,12132624300,R1250GS Coil over Plug stick coil,R1250GS ADV Coil over Plug stick coil,R1250R Coil over Plug stick coil,R1250RS Coil over Plug stick coil,R1250RT Coil over Plug stick coil

Alternative Views:

Part #: SCoil157

Coil Over Plug, Ignition Stick Coil.

Vehicle Manufacturer: BMW
Application: BMW Hexhead Models
Make/Model: BMW R1250GS, R1250GS ADV, R1250R, R1250RS, R1250RT
Model Years: 2017 - 2020
Manufacturer #: 12 13 8 567 157, 12 13 2 624 300, ZSE256

(See APPLICATION TABLE tab BELOW to verify vehicle fitment)

Original Equipment: BERU

Made in Italy

BMW List Price $224.31

USD Price $207.52

BUY NOW $99.99

Quantity in Stock:13

Part #: SCOIL157

Quantity:

Description

Application Table

There is a BMW Technical Service Bulletin out that states it is recommended to replace all stick coils at once for proper ignition function.

Improved design with stainless steel jacket for strength and heat reflection
1K Ohm total resistance

The rotation angle of the connector terminal on the 90 degree angle coil will require a simple minor modification to the plastic coil cover for proper alignment.

Please refer to the Installation Guide for additional details.

Installation Guide:
Due to operating time, heat and aging, the spark plug connector becomes brittle.
As a result, the terminal connection becomes loose in the sealing are of the spark plug, which may cause misfiring, etc...

Switch off the IGNITION. Wait for 15 minutes before removing the spark plug coil. This prevents voltage peaks that may damage or destroy the Engine Electronic Control Unit .
Remove the defective coil.
Apply a thin film a dielectric grease to the neck of the spark plug, or the inner part of the rubber sealing boot.
Re-attach the spark plug coil to the spark plug.
Check the primary connector contacts for oxidation and clean if required. Apply dielectric grease for improved continuiry and future oxidation prevention.