Home > K Bike > Custom >

Complete Radiator Hose Kit - BMW K1 Bike / EnDuraLast

Alternative Views:

Part # RadHoseKitK1

Complete Radiator Hose Kit Specifically Designed for BMW K1 Models

Silicone Hose Kits are of exceptional quality for a perfect fit.

No Longer available from BMW

Vehicle Manufacturer: BMW
Application: BMW K Bike Models
Make/Model: BMW K1
Model Years: 1988 - 1993
Manufacturer Hoses #: 17 12 1 461 886, 17 12 1 461 887, 17 12 1 460 266, 17 12 1 460 692, 17 12 1 460 314, 17 12 1 460 494
Manufacturer Clamp #: 07 12 9 952 113, 07 12 9 952 117

(See APPLICATION TABLE tab BELOW to verify vehicle fitment)

Premium Aftermarket :

USD Price $199.00

Quantity in Stock:1

Part #: RADHOSEKITK1

Quantity:

Description

Application Table

Installation Tips

Park your motorcycle safely, turn off the engine and allow the engine, coolant and radiator pipes to cool (for about 8 hrs)
Remove the existing radiator hoses and clamps and replace them with the new parts in this kit.
Choose the apporopriate hose clamps and slide them onto the hose before installating the hose.
Ensure each radiator hose seats completely as it should. Slide each hose at least 3mm (1/8-inch) onto the pipe or fitting, ensuring the hose slides over the fitting bead or lip where applicable.
The interior lining of the radiator hoses is delicate - be careful not to damage this lining when sliding hoses onto the fittings.
The clamps are designed to be torqued to 7Nm (5ft/lb) - retorque all clamps after 30minutes to compensate for any settling and stretching of the hose.
Use only cool water to lubricate hoses during installation
Use only the recommended coolant - coolant additives may damaged the hose lining.
Once the cooling system is completely full, inspect the hoses for any leaks before starting the engine.
Start the motorcycle, let it idle and again check for any leaks as the cooling system is pressurised
Check the hoses and clamps periodically.