- 100% tested ultrapremium sealing
valve; prevents corrosion of cosmetic parts from sulfuric acid.
- Exclusive gel electrolyte includes
sulfuric acid, fumed silica, pure demineralized, deionized water, and a
phosphoric acid additive that prevents crystallization of electrolyte.
-
East Penn is the only battery
manufacturer to use tank formation to activate battery plates. This
guarantee's a formed and voltage matched plate.
-
Calcium positive and negative full-frame power path grids provide the highest
cranking amps and the lowest self-discharge rates for off season storage
-
High density oxide provides maximum power-per-pound for dependable "high
cycling" service.
-
Front or top threaded holes for ease of cable installation.
-
Stainless steel terminal bolts eliminate rust and corrosion.
- CCA 220
-
24 month warranty
Learn more about AGM batteries
here.
Euro MotoElectric batteries are fresh
from battery factory production! Then prior to shipping to our customers
we maintain our batteries on a Battery Tender. Our Battery Tender shop
charger fully charges EME batteries and maintains proper storage voltage
until it goes out for shipment. The Battery Tender uses BTP
Microprocessor Technology and performs 4-step Charging.
1. Initialization: Monitor Circuit
verifies appropriate battery voltage levels and good electrical
continuity between the battery and the charger DC output.
2. Bulk Charge: Constant Current at Full
Power. Bulk Charge ends at approximately 75% to 80% of full battery
recharge.
3. Absorption Charge: Constant Voltage at
Absorption Level. This conditions the battery for optimum performance.
Absorption charge ends when the battery charging current drops below the
optimum recharge threshold or the absorption timer expires.
4. Float Charge: Constant Voltage at
Float / Maintenance level. Keeps battery fully charged and maintains
high specific gravity. Full charge reset monitor protects battery
against excessive appliance current draw while charging. Float charge
continues indefinitely.
Your battery is susceptible to damage if overcharged/undercharged. We
recommend the use of a voltage regulated battery charger having on
charge voltage, at room temperature, at or between 14.4 to 14.6 volts at
68°F (20°C). The only way to determine state of charge of your battery
is with a voltmeter.
